Replacing Engine Mount/Front Left Side Frame Connection (Front Left Wheel Arch Removed) (Cooper, Cooper S, John Cooper Works)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Observe procedure for REPAIR STAGE 3 .
Read contents of BODY, GENERAL .
Spot-weld bonding is used on this vehicle. Observe specific PROCEDURE .
For stripping and rigging operations, refer to texts on KSD CD (job number 41 14 531).
Following new body parts are required (see Electronic Parts Catalog):
- Connection, wheel arch/entrance
Removal:
Open welded connections in area (1).
Open welded connections in areas (1) and remove connection between the engine mount and side frame.
Preparation of new part:
Fit in new part.
Installation:
Install new part and weld in area (1).
Weld new part in the areas (1).