Replacing Engine Mount With Front Right Wheel Arch In Front Of Bulkhead (Cooper, Cooper S, John Cooper Works)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Observe special procedure for vehicle identification number (order body new part with vehicle identification number if required).
REFER TO PROCEDURE IN REPAIR INSTRUCTIONS "ENGINE MOUNT IN FRONT OF BULKHEAD WITH LEFT WHEEL ARCH" and transfer schematically to the vehicle.
Preparation of new part:
Prepare new parts in areas (1) up to (3) for joints through welding.
NOTE:
All 3 panels must be welded to each other in areas (3).
Increase size of holes in areas (3) (open welded connections) top 0 10 mm. Transfer holes to new engine mount internal part and drill.
Installation:
Install new parts and reinforcement plate to fit with alignment bracket or universal fixture.
Weld new parts in areas (1) to (3).