Enter Vehicle Identification Number (Cooper, Cooper S, John Cooper Works)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

83 30 2 359 240

NOTE: If the stamped vehicle identification number is removed during a repair, it must be stamped in again.
Read and comply with General Notes.

Preliminary work needed:

Remove FRONT RIGHT SPRING STRUT .

Set of special tools 83 30 2 359 240 for stamping vehicle identification number consists of:

Guide plate (1)

Counter-support plate (2)

screw

Courtesy of BMW OF NORTH AMERICA, INC.

Position counter-support plate on spring strut from bottom.

Position guide plate (1) on spring strut support plate from top and screw to counter-support plate.

Insert punch numbers (2) individually into guide plate and stamp vehicle identification number

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In the event of component or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW symbol.
Note national regulations.