Removing and installing or replacing flat motor for front left or right power electric windows (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove FRONT POWER WINDOWS .
Removal:
Unscrew the screws (1).
Detach flat motor (2) from power electric windows (3).
Installation:
NOTE:
Diagram similar.
Make sure drive shaft (2) is correctly seated in mounting (1) at power electric windows (3)!
Ensure that the flat motor (2) is assembled without tension.
Position flat motor (2) correctly on power electric windows (3).
Tighten down screws (1).
Tightening torque 51 33 4AZ .
Required reworking:
- Install FRONT POWER ELECTRIC WINDOWS .
An initialization must be carried out in order to activate crush guard.
Read and comply with NOTES on initialization of power electric windows.