Removing and installing/replacing backrest for left rear seat (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of hardening)
- Microencapsulated screws must not be retightened.
- Thread of nut must be cleaned beforehand in event of repeated use
Removal:
Unlock and fold both rear seat backrests.
Lift off cover (1).
Loosen screw (1).
Take off holder (2).
Put up rear seat backrest (1) at an angle of approx. 45°.
Take out frame (2) of backrest (1) upwards at first in the center from the mounting (3).
Take out frame (2) of backrest (1) out of the guide (4) in direction of center of vehicle.
Installation:
Insert rear seat backrest (1) into guide (4) at an angle of approx. 45°.
Insert frame (2) of rear seat backrest (1) into mounting (3).
Feed in holder (2).
Tighten screw (1).
Tightening torque 52 26 2AZ .
Clip in cover (1).
Fold up and lock both rear seat backrests.