REP-TAT-P-5218-25 When replacing the seat frame: Remount components
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Removing the LATCH anchor for the front passenger seat
NOTE:
The operations shown only for one side must be carried out on both sides.
- Drill out the blind rivets (1).
- Remove the LATCH anchor (2) for the front passenger seat.
Removing front lower strap
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Loosen screw (1).
- Unclip the cable clip (2).
- Feed the cable (1) out of the seat mechanism.
- Release cable tie (1).
- Carefully unlock the detents (markings).
- Thread the matching connector plugs (2) in the direction of the arrow out of the connector plug housings (3).
Installing the front lower strap
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Insert the appropriate connectors (1) into the connector housing (2) and clip them in.
- Fasten the cable (3) on the connector housing (2) using a cable tie.
- Hook the cable (1) into the seat mechanism.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
- Clip in the cable bracket (2).
Installing the LATCH anchor for the front passenger seat
- Position the ISOFIX anchor (2) for the front passenger seat.
- Replace blind rivets (1).
Parts: Blind rivet
NOTE:
The operations shown only for one side must be carried out on both sides.
- Secure the ISOFIX anchor (2) for the front passenger seat using blind rivets (1).