REP-TAT-P-5218-25 When replacing the backrest frame: Remount components
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Remove operating unit for backrest release
- Move the operating unit (1) in arrow direction and feed out Bowden cable (2).
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Drill out the blind rivets (1).
- Feed out the operating unit (2) towards the front.
- Unclip Bowden cable (1) from the holder (2) and feed out from the operating unit (3).
Remove the support
- Drill out the blind rivet (1).
- Loosen the detents (2).
- Feed out support (3) from the backrest frame (4).
Removing the head restraint guides
- Unlock the detents (1).
- Feed out head restraint guides (2) upwards from the backrest frame (3).
Remove lumbar support
- Detach lumbar support (3) from the holders (1) and backrest frame (2).
- Cover working area and drill out blind rivet (1).
- Remove adjuster (2) and take it out with the Bowden cable from the backrest frame.
Install lumbar support
- Insert the adjuster (2) with Bowden cable in the backrest frame.
- Replace the blind rivets (1).
Parts: Blind rivet
- Secure adjuster (2) with the blind rivet (1) on the backrest frame.
- Attach lumbar support (3) in holders (1) and backrest frame (2).
Installing the head restraint guide
NOTE:
TECHNICAL INFORMATION
The head restraint guides are not identical in construction.
The head restraint guides are not identical in construction.
- Ensure that the headrest guide (2) is installed on the left side with the lock for head restraint when facing the direction of travel.
- Insert the head restraint guides (2) correctly from the top in the backrest frame (3).
The detents (1) must engage audibly.
Install support
- Position the support (3) correctly on the backrest frame (4).
- Engage the detents (2).
- Replace the blind rivets (1).
Parts: Blind rivet
- Secure the support (3) with the blind rivets (1) on the backrest frame (4).
Install operating unit for backrest release
- Correctly position Bowden cable (1) on the operating unit (3) and clip it into the holder (2).
- Correctly position the operating unit (2).
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Replace the blind rivet (1).
Parts: Blind rivet
- Secure the operating unit (2) with blind rivets (1).
- Move the operating unit (1) in arrow direction and insert Bowden cable (2).