REP-TAT-P-5218-02 Installing the head restraint
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Correctly position the head restraint (2).
- Press the locks (1) and install the head restraint (2) in arrow direction.
- Correctly position impact plate (1) on the support (3).
- Clip in impact plate (1) in the marked areas (2).
- Tighten down screw (1).
Tightening torques
TIGHTENING TORQUE SPECIFICATION
| Screw | Tightening torque 2.2 Nm |
Required follow-up work
Install the TRIM at the bottom of the aperture
Install the REAR PANEL from the front seat backrest
Install TRIM for backrest release