Remove and install/replace seat height adjustment lever on left or right front seat (from 07/2014) (Except John Cooper Works)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

2 298 505

IMPORTANT:

Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of harden)
Microencapsulated screws must not be retightened.
Thread of nut must be cleaned beforehand in event of repeated use

Removal:

Unclip cover (1) with special tool 2 298 505.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove lever (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position lever (2) and tighten screw (1).

Tightening torque 52 10 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Insert cover (1) at bottom and engage in upwards direction.

Courtesy of BMW OF NORTH AMERICA, INC.