Removing and installing/replacing rear right ultrasonic sensor (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Removal:
Remove screw (1).
Place wheel arch cover (2) slightly to one side.
Unfasten plug connection (1) and disconnect.
Unlock latches at marked points.
Remove ultrasonic sensor (2).
Installation:
NOTE:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).
NOTE:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).
Engage ultrasonic sensor (2) in holder.
Join and lock plug connection (1).
Position wheel arch cover (2) correctly.
Tighten screw (1).