Removing and installing/replacing one rear middle right ultrasonic sensor (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of burning!

Work on the exhaust system may only be carried out when it has cooled down!

Removal:

Unfasten plug connection (1) and disconnect.

Unlock latches at marked points.

Remove ultrasonic sensor (2) from holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!

Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Engage ultrasonic sensor (2) in holder.

Join and lock plug connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.