Removing and installing/replacing a front center left (inside) ultrasonic transducer (Park Distance Control) (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove front BUMPER COVER .

Removal:

Unlock detents (1).

Pull out ultrasonic sensor (2) upwards out of holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!

Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Engage ultrasonic sensor (2) in holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Install front BUMPER COVER .