Removing and installing/replacing seal for trunk lid (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed :
- Open LOADING AID
Detach seal (1) from trunk lid cutout.
Installation note:
Start lining in area of filler pieces (2).
Make sure filler pieces (2) are correctly seated on tail panel bolts.
Drain hole of seal in middle on trunk lid cutout must not be clogged.
NOTE:
Seal (1) runs under soft top up to B-pillar.
Detach seal (1) on left and right from body.
Installation note:
Make sure seal (1) is correctly seated on body and all trim panel parts.