Removing and installing belt feed cover (Cooper)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed :
- Remove REAR SEAT .
- Reposition rear backrest
- Remove the TRIM PANEL for the top rollover protection.
Removal:
Lever out the seat belt finisher strip (1) towards the top.
Remove screw (1).
Remove end lining (2).
Remove the seat belt strap (1) from the seat belt finisher strip (2).
Installation:
Insert the seat belt strap (1) into the seat belt finisher strip (2).
Mount end lining (2).
NOTE:
End lining (2) is encoded to prevent incorrect assembly.
Tighten screw (1).
Tightening torque 72 11 22AZ .
Position and lock the seat belt finisher strip (1).
Required reworking :
- Install the TRIM PANEL for the top rollover protection.
- Fold back the rear seat backrest
- Install REAR SEAT .