Removing and installing/replacing drive unit for tailgate lock (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove tailgate TRIM PANEL .

Removal:

Unscrew nuts (1).

Turn drive unit for lift gate latches (2) upwards.

G13797509

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Take out cover for theft protection (2) from the guide (3).

G13797510

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on controller drive.

Unclip Bowden cables (2).

Remove engine of lift gate latch (3).

G13797511

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install engine of lift gate latch (3).

Clip in Bowden cables (2).

Connect plug connection (1) on controller drive.

G13797512

Courtesy of BMW OF NORTH AMERICA, INC.

Insert cover for theft protection (2) into the guide (3).

Tighten nut (1).

G13797513

Courtesy of BMW OF NORTH AMERICA, INC.

Install engine of lift gate latch (2).

Tighten down nuts (1).

Tightening torque 51 24 7AZ .

G13797514

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the tailgate TRIM PANEL .