REP-TAT-P-5114-02 Installing the model inscription
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Further information is available .
NOTE:
Technical information NOTES
on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES on component bonding with adhesive tape
on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES on component bonding with adhesive tape
CAUTION:
Laser beam.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Park the vehicle and the special tool 2 407 566 on a flat and even surface.
- Mount the laser on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Position the tool behind the vehicle.
- Align vertical laser beam at the center of the mini emblem.
- Align the horizontal laser beam on the edge of the handle with the dimension (A) = 17 cm.
- Remove the adhesive residues and clean the bonding surface.
| Consumable | ||
|---|---|---|
| Cleaning agent R2 | 500 ml | 83190417324 |
- Detach the liner (protective film) from the adhesive strip of the model inscription.
- Align the model inscription on the laser beams with the dimension (B) = 33 cm and press on to the tailgate.