Fill/inflate tire
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
TECHNICAL INFORMATION Observe country-specific regulations and the regulations of the trade associations.
- Remove all installation aids.
- Utilize the options to safely mount the wheel. Place the wheel into a holding device.
- Inflate tire with air (without valve insert).
- Increase the pressure up to 3.3 bar in stages (fitting pressure).
- If the tire bead does not slip on to the rim flange all round: Do not increase the pressure under any circumstances.
- If necessary, release air and force off tire bead again.
- Apply coating of tire-lining past to rim flange and tire again.
- Inflate the tire again up to 3.3 bar.
- If the tire bead is mounted correctly onto rim flange: Increase the tire pressure to a maximum of 4.0 bar set pressure.
- Screw in the valve insert and tighten to torque.
- Correct tire pressure.