Replacing one front pulse sensor (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove WHEEL
- Partially detach front wheel ARCH TRIM PANEL .
Removal:
Release screw (1) and remove pulse sensor (2).
Remove cable from holder on spring strut.
Disengage cable from holders (1).
Disconnect plug connection (2).
Installation:
Clean hole for pulse sensor and grease with Staburags NBU 12/K lubricating grease.
IMPORTANT:
Check sensor head prior to installation for damage, replacing if necessary.
Attach brake pad wear sensor in holders (1).
Connect plug connection (2).
Install pulse sensor (2).
Insert screw (1) and tighten.
Tightening torque 34 51 4AZ .
Install cable in holder on spring strut.
Required follow-up work:
- Install front WHEEL ARCH TRIM PANEL .
- Install WHEEL .