Replacing a rear pulse sensor (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove the rear WHEEL .
- Partially detach the rear ARCH PANEL .
Removal:
Take the cable out of the holder (1).
Release screw (2) and remove pulse sensor (3).
Disconnect plug connection (1).
Disengage cable from holders (2).
Installation:
Clean hole for pulse sensor and grease with Staburags NBU 12/K lubricating grease.
IMPORTANT:
Check sensor head prior to installation for damage, replacing if necessary.
Attach brake pad wear sensor in the holders (2).
Connect plug connection (1).
Install cable in holder (1).
Install pulse sensor (3).
Fit bolt (2) and tighten.
Tightening torque 34 51 5AZ .
Required follow-up work:
- Install the rear ARCH PANEL .
- Mount the rear WHEEL .