21 00 006 Venting clutch hydraulic system

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Connect bleeder unit to brake fluid expansion tank.
Remove front UNDERBODY PROTECTION .

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.

Remove the dust cap from the bleed valve (1).

Insert air bleeder hose (2) into bleed valve (1).

Open bleed valve (1) and flush until clear brake fluid leaks out without air bubbles.

Close bleed valve.

Switch off bleeder unit or remove from expansion tank.

Correct brake fluid level in expansion tank.

Fig 1: Inserting Air Bleeder Hose Into Bleed Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.