52 26 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of hardening)
Microencapsulated screws must not be retightened.
Thread of nut must be cleaned beforehand in event of repeated use

Removal:

Unclamp cover (1) and remove.

Fig 1: Locating cover

G11649687

Courtesy of BMW OF NORTH AMERICA, INC.

Release welt in area (1).

Fig 2: Locating Welt Area

G11649688

Courtesy of BMW OF NORTH AMERICA, INC.

Press seat cover and upholstery slightly to one side.

Unclip cover (1) by releasing detents (2) and remove.

Fig 3: Removing Seat Cover

G11649689

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Remove the lock (2).

Fig 4: Removing Lock

G11649690

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position lock (2).

Tighten down screws (1).

Tightening torque 52 26 1AZ .

Fig 5: Removing Lock

G11649690

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

Ensure that detents (2) correctly engage.

Fig 6: Removing Seat Cover

G11649689

Courtesy of BMW OF NORTH AMERICA, INC.

Secure welt in area (1).

Fig 7: Locating Welt Area

G11649688

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

Fig 8: Locating Clip In Cover

G11649694

Courtesy of BMW OF NORTH AMERICA, INC.