LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Technical Data -- F54 Cooper Clubman >> Rear Brakes

Rear Brakes

34 21 REAR BRAKES BLADES F54 SPECIFICATION

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension (see table).
Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!(Not applicable to perforated brake discs and M vehicles)Applies only to M vehicles and perforated ventilated brake discs:The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!Depending on:
  • Engine type
  • Transmission version
  • Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.)
different brake discs can be fittedThe brake discs must always be assigned byway of the relevant vehicle identification number and the Electronic Parts Catalog!		    
Thickness difference in the friction surfaces of the brake disc Max. mm 0.01
Nominal size (diameter x thickness) mm 300x20
Minimum brake disc thickness stamped on brake disc chamber mm 18.4
Nominal size (diameter x thickness) mm 280x10
Minimum brake disc thickness stamped on brake disc chamber mm 8.4
Pad wear warning from remaining brake pad thickness mm 3.7
scientia non olet · About LEMON Manuals