Removing and installing/replacing switch for electromechanical parking brake

Preliminary work needed: 

• Disconnect CABLE  from battery earth lead
• Partially remove the CENTER CONSOLE TRIM .

Removal: 

Unlock and disconnect connector (3).

Undo all screws (1) if necessary.

Remove switch for electromechanical parking brake (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position switch for electromechanical parking brake (2).

Tighten all screws (1).

Tightening torque 61 31 4AZ .

Connect connector (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the CENTER CONSOLE TRIM .
• Connect BATTERY GROUND LEAD .