Removing and installing/replacing power window switch (driver's side)

Special tools required:

00 9 327

IMPORTANT: Carry out the following operation carefully so as to avoid damaging the door trim panel and switch.
If necessary, tape off working area.

Removal:

Press cover (1) in marked area toward the bottom.

Feed out cover (1) towards top.

G12684686

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

G12684687

Courtesy of BMW OF NORTH AMERICA, INC.

Lift the power window switch (1) out of the armrest (2) in arrow direction using special tool 00 9 327.

Unlock plug connection underneath and disconnect.

G12684688

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release the detents on both sides and feed the power window switch (1) out of the trim (2).

Clip in the power window switch spare part (2) into the trim (1).

NOTE: Ensure the power window switch (2) engages correctly in the trim (1).

G12684689

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Clips must not be damaged or missing.

G12684690

Courtesy of BMW OF NORTH AMERICA, INC.

Connect associated connector.

Feed in and clip in the power window switch (1) into the armrest (2).

NOTE: Make sure the power window switch (1) is correctly fitted in the armrest (2).

G12684691

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1).

G12684687

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1).

G12684693

Courtesy of BMW OF NORTH AMERICA, INC.