Removing and installing power distribution box (front)
WARNING:
Observe SAFETY INSTRUCTIONS
for handling vehicle battery.
Preliminary work needed:
- Remove TRIM for dashboard at bottom right.
- Remove right GLOVE COMPARTMENT WITH HOUSING .
Removal:
Remove screw (1).
Feed out power distribution box (2) from support (3).
Installation:
Feed in power distribution box (2) into support (3).
Tighten screw (1).
Tightening torque 61 14 3AZ .
Required follow-up work:
- Install right GLOVE COMPARTMENT WITH HOUSING .
- Install bottom right INSTRUMENT PANEL TRIM .