Removing and installing/replacing rear anti-roll bar

Preliminary work needed: 

• Lower rear AXLE SUPPORT .

Removal: 

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

• If necessary, counter-hold at the Torx socket.

Remove anti-roll bar link (2) from anti-roll bar on left and right.

Unscrew the screws (1).

Remove retainers.

Feed out anti-roll bar to one side.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in anti-roll bar from the side and position. Set down retainer.

Tighten down screws (1).

Tightening torque 33 55 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Insert anti-roll bar link (2) into anti-roll bar on left and right.

Part  : Replace nuts (1).

Tighten down nuts (1).

• If necessary, counter-hold at the Torx socket.

Tightening torque 33 55 1AZ .

Required follow-up work: 

• Raise rear AXLE SUPPORT .