Removing and installing/replacing bottom left wishbone (FWD)

NOTE: If the bottom wishbone is detached from the rear axle support/trailing arm, wheel alignment must be carried out after installation. Refer to: KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLE

Preliminary work needed:

Removal:

Remove rear heat shield (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Mark position of eccentric shim to trailing arm to simplify subsequent adjustment of rear axle.

Release nut and remove screw (2).

Slacken nut (1).

Remove eccentric washer and unscrew screw.

Remove wishbone (3).

Installation note:

Tighten screw connection (1) and (2) in NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Courtesy of BMW OF NORTH AMERICA, INC.

Align wishbone (3).

Insert bolt (1) and connect eccentric shim.

Align eccentric shim to marked position.

Tighten nut (1) in NORMAL POSITION (not until wheel alignment).

Part : Replace screw and nut (1).

Tightening torque 33 32 2AZ .

Insert bolt (2) and screw on new nut.

Part : Replace nut.

Shift vehicle into NORMAL POSITION .

Tighten nut of bolt (2) in normal position.

Tightening torque 33 32 3AZ .

Mount heat shield (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: