Rear axle: Perform wheel alignment after the following repair work

Courtesy of BMW OF NORTH AMERICA, INC.

Perform either KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLEafter the following repair work: 

• Release the following screw connection: 
  • Trailing arm bearing support to body
  • Upper wishbone to rear axle carrier
  • Bottom wishbone at the rear axle support/trailing arm
• Replacement of following parts: 

1. Rear axle carrier
2. Upper wishbone
3. Lower wishbone
4. Trailing arm/trailing arm bearing support/rubber mount