Replacing a rear pulse sensor (Cooper)

Preliminary work needed: 

• Remove the rear WHEEL .
• Partially detach the rear ARCH PANEL .

Removal: 

Take the cable out of the holder (1).

Release screw (2) and remove pulse sensor (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Disengage cable from holders (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clean hole for pulse sensor and grease with Staburags NBU 12/K lubricating grease.

Courtesy of BMW OF NORTH AMERICA, INC.

Attach brake pad wear sensor in the holders (2).

Connect plug connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install cable in holder (1).

Install pulse sensor (3).

Fit bolt (2) and tighten.

Tightening torque 34 51 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the rear ARCH PANEL .
• Mount the rear WHEEL .