Replacing backrest cover for left rear seat

Special tools required: 

• 52 0 050

The seat frame has very sharp edges that can cause injuries from cuts.

Exercise extreme caution and wear work gloves as required when carrying out any repair work in the area of the seat frame.

Preliminary work needed: 

• Remove left REAR PANEL  on rear seat backrest
• Remove left GUIDE SLEEVES  for head restraint

Removal: 

Remove screw (1).

Remove outer bearing (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Press seat cover and upholstery slightly to one side.

Press detents (1) downwards and unclip cover (2) outwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screw (1).

Detach seat belt finisher strip (2) upwards.

Feed out seat belt strap (3) from seat belt finisher strip (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out entire seat cover welt (1) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out backrest frame (1) from seat cover and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover (1) from upholstery: 

• Disconnect all clamps in marked area (2).
• Remove cover (1) from upholstery
• Remove all remnants of clips from cover (1) and upholstery.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Pull seat cover (1) over upholstery and mount clamps in marked area (2).

Parts:  Replace clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert new clamp (2) with special tool 52 0 050 and bend closed.

1. Upholstery
2. Clamp
3. Trim wire in upholstery
4. Trim wire in seat cover
5. Seat cover

Parts:  Replace clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in backrest frame (1) into seat cover.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed seat belt strap (3) into seat belt finisher strip (2).

Clip in seat belt finisher strip (2) from above.

Tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Put on outer bearing (2).

Tighten screw (1).

Tightening torque 52 26 7AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1) from above.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Install left REAR PANEL  on rear seat backrest
• Install GUIDE SLEEVES  for left head restraint