Removing and installing/replacing lock for left or right rear seat backrest

IMPORTANT:

Removal:

Insert screwdriver into the trim (1) and lightly push the detent downwards into area (2).

Feed trim (1) outwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Release welt in area (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Press seat cover and upholstery slightly to one side.

Press detents (1) downwards and unclip cover (2) outwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Feed out lock (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in lock (2).

Tighten down screws (1).

Tightening torque 52 26 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Secure welt in area (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Insert trim (1) in area (2).

Clip in trim (1) in area (3).

NOTE: Make sure the trim (1) is engaged properly.

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in cover (1) from above.

NOTE: Make sure the cover (1) is engaged properly.

Courtesy of BMW OF NORTH AMERICA, INC.