REP-TAT-P-5218-02 Installing the head restraint
NOTE:
To provide a better overview:
Schematic diagram with partially hidden components.
- Correctly position the head restraint (2).
- Press the locks (1) and install the head restraint (2) in arrow direction.
- Correctly position impact plate (1) on the support (3).
- Clip in impact plate (1) in the marked areas (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Impact plate to support | |
| Screw | |
| Tightening torque | 2.2 Nm |
Follow-up work
- Install the TRIM at the bottom of the aperture
- Install the REAR PANEL on the front seat backrest