Replace the front deformation element on the bottom right

Preliminary work needed: 

• Remove front bottom SUPPORT  for bumper cover.
• Release FLUID FUEL TANK for washer system.

Removal: 

Only MINI Cooper S: 

Release expanding rivet (1).

Remove screw (2).

Feed out air duct (3) from guide (4) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 to 3).

Remove deformation element (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert deformation element (4).

Tighten screws (1 to 3).

Screw	Tightening torque
(1)	51 11 9AZ .
(2)	51 11 4AZ .
(3)	51 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Only MINI Cooper S: 

Feed in air duct (3) with guide (4) into holder.

Secure air duct (3) with screw (2) and expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install front bottom SUPPORT  for bumper cover.
• Secure WASHER FLUID RESERVOIR for washer system.