Removing and installing (replacing) left B-pillar sensor (Cooper)
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic discharge (ESD protection)!
WARNING:
NOTE
airbag safety regulations!
Failure to observe correct procedures can deploy the airbag and cause injuries.
Preliminary work needed:
- Disconnect BATTERY GROUND LEAD and cover
- Remove door pillar TRIM PANEL .
Removal:
Unfasten plug connection (1) and disconnect.
Remove screw (2).
Remove sensor (3).
Installation:
Position sensor (3).
Tighten screw (2).
Tightening torque 65 77 2AZ .
Connect and lock plug connection (1).
Required reworking:
- Connect BATTERY GROUND LEAD .
- Install door pillar TRIM PANEL .