Replacing FLEL control unit (Cooper)

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Preliminary work needed:

Removal:

Loosen screws.

Remove front light electronics control unit (1) from headlight (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Gasket (1) for front light electronics control unit (2) must not be damaged and must be installed free from grease.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert front light electronics control unit (1) into headlight (2).

Tighten the screws.

Tightening torque 63 12 3AZ .

NOTE: Ensure front light electronics control unit (1) is correctly fitted.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Replacement only: