Removing and installing/replacing one rear left ultrasonic sensor (Cooper)
WARNING:
Risk of burning!
Work on the exhaust system may only be carried out when it has cooled down!
Removal:
Unfasten plug connection (1) and disconnect.
Unlock latches at marked points.
Ultrasonic sensor (2)
Installation:
NOTE:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).
NOTE:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Safety catches (1) of ultrasonic transducer (2) must engage exactly in mountings (3).
Engage ultrasonic sensor (2) in holder.
Unfasten plug connection (1) and disconnect.