Remove and install/replace control unit for fuel pump control electronics (EKPS) (Cooper)
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic discharge (ESD protection)!
Preliminary work needed:
- Remove REAR SEAT BENCH .
Removal:
Disconnect plug connection (1).
Release nuts (2) and remove control unit (3).
Installation:
Install control unit (3).
Insert nuts (2) and tighten.
Tightening torque 16 14 1AZ .
Position plug connection (1) and lock.
Required follow-up work:
- Install REAR SEAT BENCH .
- Replacement only: Perform initial operation of electric fuel pumps-control electronics using appropriate scan tool.