Removing and installing/replacing pressure switch for Natural Vacuum Leak Detection (Natural Vacuum Leak Detection) (US version with Natural Vacuum Leak Detection) (Cooper)

Preliminary work needed: 

• Remove rear left WHEEL ARCH PANEL .

Removal: 

Unlock and disconnect snap fastener (1).

Release clamp (2) and detach line.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Operate lever (2) and remove holder for pressure switch (3) downwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert holder with pressure switch (1) into the holder.

Lever (2) must engage in the holder.

Connect plug connection (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Replace clamp (2).

Fit line and tighten clamp (2).

Parts:  cl.

Position snap fastener (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install rear left WHEEL ARCH PANEL .