Replacing positive battery cable (from battery to front power distribution box)

WARNING: Follow SAFETY INSTRUCTIONS for handling the vehicle battery.

Preliminary work needed:

Removal:

Release upper housing section (1) from lower housing section in arrow direction and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove positive terminal cable (2) of power distribution box positive battery cable.

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove positive terminal cable (2) of battery terminal positive terminal (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Join positive terminal cable (2) to battery terminal positive terminal (3) and tighten nut (1).

Tightening torque 61 21 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten positive terminal cable (2) to power distribution box positive battery cable with nut (1).

Tightening torque 61 21 3AZ .

NOTE: Risk of short circuits!
Make sure flat positive terminal wire (2) is correctly seated.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Retaining lugs on upper housing section (1) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.

Join upper housing section (1) to lower housing section in arrow direction.

NOTE: Ensure upper housing section engages correctly (1) engages correctly in lower housing section.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: