Adjusting rear axle (Cooper Convertible)

Special tools required:

NOTE: A camber change always means a track change as well. The camber must therefore be adjusted first.

If camber and toe-in are not adjustable within setpoint range: Troubleshooting at rear axle.

Adjusting camber:

Replace the eccentric screw (1) and nut and tighten to 5 Nm prior to setting.

Turn screw (1) and adjust camber to setpoint value.

Tighten nut (1).

Parts: replace nut.

Tightening torque 33 32 2AZ .

Adjusting track:

replace the screws (1) and (2) and tighten to 5 Nm prior to setting.

Mount special tool 32 4 200 on screw (2).

Turn special tool 32 4 200 and adjust toe-in to setpoint value.

Tighten down screws (1).

Tightening torque 33 32 5AZ .