Removing and installing/replacing backrest for left rear seat (Cooper Convertible)
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of hardening)
- Microencapsulated screws must not be retightened.
- Thread of nut must be cleaned beforehand in event of repeated use
Removal:
Unlock and fold both rear seat backrests.
Lift off cover (1).
Loosen screw (1).
Take off holder (2).
Put up rear seat backrest (1) at an angle of approx. 45°.
Take out frame (2) of backrest (1) upwards at first in the center from the mounting (3).
Take out frame (2) of backrest (1) out of the guide (4) in direction of center of vehicle.
Installation:
Insert rear seat backrest (1) into guide (4) at an angle of approx. 45°.
Insert frame (2) of rear seat backrest (1) into mounting (3).
Feed in holder (2).
Tighten screw (1).
Tightening torque 52 26 2AZ .
Clip in cover (1).
Fold up and lock both rear seat backrests.