Removing and installing/replacing trim for left or right A-pillar (Cooper Convertible)

Preliminary work needed:

Remove TRIM STRIP from side wall.

Removal :

Release door weather strip (1) in area of A-pillar.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Release the cover (2) at clips (3) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: If necessary, release fixtures (2) from A-pillar (1).
The sealing rings of the clips (2) should not be damaged or missing.
The seal (3) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Replace faulty grommets (1) on A-pillar (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Place and clip in trim (2) with clips (3) on car body.

Tighten down screws (1).

Tightening torque 51 13 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Fasten door weather strip (1) in area of A-pillar.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install TRIM STRIP on side panel.