Replacing wiring harness section for injectors and ignition coils (B38) (Cooper Convertible)

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Preliminary work needed:

Removal:

Partially detach seal (1).

Open locks by counterclockwise turn.

Release screws (2) and remove battery cover (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip and remove cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect all connectors (1) on control unit.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sound insulation from high pressure pump.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Overview of wiring harness section for injector and ignition coil

Unlock and disconnect following connectors and lines	Note
Unlock and disconnect connector from DME control unit
Release connector from ignition coils and unplug
Release and detach connector from injectors

Release wiring harness from clips and guard controls.

Feed out wiring harness and remove.

Installation:

Route and install wiring harness.

All connectors must audibly engage.

Connect all connectors (1) to control unit.

All connectors (1) must engage audibly.

Installation note:

Connect connectors from front to rear.

Courtesy of BMW OF NORTH AMERICA, INC.

Install cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Join battery cover (3) and tighten screws (2).

Tightening torque 61 21 6AZ .

Turn locks up to stop against arrow direction.

Join gasket (1) and press down firmly.

Courtesy of BMW OF NORTH AMERICA, INC.

Install sound insulation for high pressure pump.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: