11 37 020 Removing and installing/replacing servomotor for eccentric shaft (B48, B46)

Necessary preliminary tasks:

Removal:

Release screw (1).

Remove top partition wall (2) in upwards direction.

Fig 1: Top Partition Wall And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1).

Fig 2: Servomotor Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Servomotor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Attention !

Risk of damage to intermediate shaft.

Release intermediate shaft:

Turn servomotor (1) in direction of arrow to the left by means of reversible ratchet (2) and 4 mm hexagon socket wrench.

NOTE: Do not rotate shaft too far (maximum/end stop).

Fig 4: Turning Servomotor

Courtesy of BMW OF NORTH AMERICA, INC.

Remove actuator drive.

Installation:

Detach and replace gasket (1) in direction of arrow.

Fig 5: Checking Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Press-in gasket (1) up to limit position on housing.

Fig 6: Gasket On Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Insert controller drive (1) as far as the gearing.

Screw in controller drive (1) using reversible ratchet (2) and 4 mm hexagon socket wrench in direction of arrow up to limit position.

Fig 7: Screwing In Controller Drive Using Reversible Ratchet

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque: 11 37 2AZ .

Fig 8: Servomotor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1).

Fig 9: Servomotor Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Install top partition wall (2).

Tighten screw (1).

Fig 10: Top Partition Wall And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: