12 41 041 Replacing the engagement solenoid switch

Necessary preliminary tasks:

Slacken nut (1).

Remove the cable shoe (2).

Fig 1: Cable Shoe And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not twist the cable shoe (2) when tightening, risk of shorting to starter motor housing.

Tightening torque 12 41 1AZ .

Release screws (1).

Fig 2: Starter Motor Housing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the solenoid switch (1) and the spring (2).

Detach the bolt (3).

Installation note:

Check the bolt (3) for wear and grease the bolt.

Fig 3: Solenoid Switch, Spring And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.