Install automatic transmission
Bore (1) of driving plate must be accessible from recess on motor oil engine oil pan. Check lining sleeves (2...3) are correctly seated.
Replace damaged lining sleeves.
Rotate torque converter until bore in torque converter is flush with bore in drive plate.
Flange-mount automatic transmission to engine and screw on.
Tightening torque 24 00 1AZ .
Crank engine with special tool 11 6 480 at vibration damper in direction of rotation.
Parts : Replace nuts (1).
Screw 6 nuts (1) on torque converter.
Tightening torque 24 40 1AZ .
With B48 4-cyl. engine:
Install heat shield (2).
Insert screws (1) and tighten.
Screw transmission on transmission mount with screws (1).
Tightening torque 22 32 1AZ .
Screw ground strap (2) on transmission with screw (1).
Graphic shows transmission oil cooler on vehicles with B47O or B48O engine.
Slide coolant hoses onto transmission oil cooler and engage locks (1).
Graphic shows transmission oil cooler on vehicles with B47M or B48U engine.
Slide the coolant hoses (1) onto the transmission oil cooler.
Secure hose clamps.
Secure clamp (2) on transmission with wiring harness.
Lock connector (1).
Press in cable (2) into the support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball pivot.
Install battery tray (5).
Tighten down screws (1).
Install wiring harness (4) on battery tray (5).
Insert control unit (3) in holder.
Insert vehicle battery partition wall (2) in holder.
Required follow-up work :
- Install FRONT AXLE SUPPORT .
- No wheel alignment is required for removal and installation of front axle support .
- Install STARTER MOTOR .
- Install TRANSFER BOX .
- Install LEFT output shaft.
- Install RIGHT output shaft.
- Install VEHICLE BATTERY .
- Top up coolant.