37 12 400 Removing and installing the support bearing for rear shock absorber (EDC) (Countryman 2017-2023, except PHEV)

Special tools required:

33 0 040

NOTE: In case of LCI vehicles from 03/21, a frequency-selective shock absorber is used with the optional equipment "adaptive suspension" (SA223). This is no longer controlled electrically and is a purely mechanical/hydraulic shock absorber!

Preliminary work needed:

Remove the REAR SHOCK ABSORBER .

Removal:

NOTE: Only for vehicles up to 03/21 with Dynamic Damping Control:

Release adapter plate (2) from support bearing.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release the nut (1) with special tool 33 0 040, reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit support bearing (2).

Part: Replace nut (1).

Tighten down nut (1) with special tool 33 0 040, reversible ratchet with extension, socket SW10 and torque wrench with ring wrench attachment SW21.

Tightening torque 33 52 3AZ .

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Only for vehicles up to 03/21 with Dynamic Damping Control:

Installation note:

Make sure cable routing (1) is in the correct position. See figure!

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Only for vehicles up to 03/21 with Dynamic Damping Control:

Connect connector (1) to shock absorber.

Fit adapter plate (2) on support bearing and engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install REAR SHOCK ABSORBER .