Install the wiring harness section for the Valvetronic servomotor

NOTE: RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.

Route all cables without abrasions, do not trap and crush.

NOTE: TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.

Insert and install the wiring harness section (2) for the Valvetronic servomotor.
Connect and lock the connector (1).
Make sure the connector (1) engages audibly.
Fasten the wiring harness section (2) for the Valvetronic servomotor on the holder (3).

G15148004

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the wiring harness section (2) for the Valvetronic servomotor in the direction of the arrow.
Ensure that the locks (1) engage audibly.

G15148006

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the wiring harness section (3) for the injectors and ignition coils in the direction of the arrow.
Ensure that the lock (2) engages audibly.
Insert and install the positive battery cable (1).

G15147990

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) in the direction of the arrow and lock.
Make sure the connectors (1) engage audibly.

G15148008

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the connector (1).
Make sure the connector (1) engages audibly.
Insert and install the connector (1) to the E-box (2) in the direction of the arrow.

G15147889

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the cover panel (2) in the guides (3) in the direction of the arrow.
Ensure that the cover panel (2) audibly engages in the guides (3).
Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Cover panel to E-box
RF5x26.5	Tightening torque	2.5Nm

G15147890

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the positive battery cable (2) on the holder (3).
Insert and install the battery positive terminal (1).
Tighten the battery positive terminal (1).

TIGHTENING TORQUES SPECIFICATION

Battery terminal clamp on battery terminal
M6	Tightening torque	5Nm

G15147882

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE TENSION STRUT .
Refer to INSTALLING THE STRUT BRACE .
Refer to INSTALLING INTAKE SILENCER HOUSING .
Refer to INSTALLING INTAKE PORT .
Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
Refer to DISCONNECTING ALL BATTERY GROUND LEADS .