Install the wiring harness section for the injectors and ignition coils
NOTE:
RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
- Route all cables without abrasions, do not trap and crush.
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
- Insert and install the wiring harness section (3) for the injectors and ignition coils.
- Tighten nut (2).
TIGHTENING TORQUES SPECIFICATION
| Ground cable on rail | ||
| M6 | Tightening torque | 5Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Wiring harness section for injectors and ignition coils to cylinder head cover | ||
| M6 | Tightening torque | 6Nm |
- Connect and lock the connector (1).
- Make sure the connectors (1) engage audibly.
- Connect and lock the connector (1).
- Make sure the connectors (1) engage audibly.
- Insert and install the wiring harness section (3) for the injectors and ignition coils in the direction of the arrow.
- Ensure that the lock (2) engages audibly.
- Insert and install the positive battery cable (1).
- Connect connector (1) in the direction of the arrow and lock.
- Make sure the connectors (1) engage audibly.
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Insert and install the connector (1) to the E-box (2) in the direction of the arrow.
- Insert and install the cover panel (2) in the guides (3) in the direction of the arrow.
- Ensure that the cover panel (2) audibly engages in the guides (3).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Cover panel to E-box | ||
| RF5x26.5 | Tightening torque | 2.5Nm |
- Insert and install the positive battery cable (2) on the holder (3).
- Insert and install the battery positive terminal (1).
- Tighten the battery positive terminal (1).
TIGHTENING TORQUES SPECIFICATION
| Positive battery terminal to battery | ||
| Nut M6 | Tightening torque | 5Nm |
Follow-up work
- Refer to INSTALLING THE TENSION STRUT .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING INTAKE PORT .
- Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .