Installing the positive battery cable from the battery to the starter
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Guide in and install the positive battery cable at the clamps (1).
- Feed the positive battery cable (2) in on the starter and install.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Battery positive lead to starter | ||
| M8 | Tightening torque | 13.5Nm |
- Insert and install sealing cap (2).
- Install sealing cap (2) in the direction of the arrow.
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Insert and install the holder (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Holder to oil pan | ||
| M6 | Tightening torque | 8Nm |
- Insert and install the positive battery cable (3) at the alternator.
- Tighten nut (2).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable to alternator | ||
| M8 | Tightening torque | 19Nm |
- Guide in and install cover (1).
- Secure the positive battery cable (3) at the clamps (4).
- Guide in and install the positive battery cable (4) at the partition panel (5).
- Tighten the battery positive terminal (3).
TIGHTENING TORQUES SPECIFICATION
| Positive battery terminal to battery | ||
| Nut M6 | Tightening torque | 5Nm |
- Guide in and install the positive battery cables (2).
- Tighten nuts (1).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable to positive battery terminal | ||
| M8 | Tightening torque | 15Nm |
- Install the tension strut (1).
- Tighten the screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Tension strut to battery tray | ||
| M8 | Tightening torque | 19Nm |
- Guide in and install cover (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Cover of remote positive terminal | ||
| screw | Tightening torque | 2.6Nm |
Follow-up work
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FAN COWL WITH ELECTRIC FAN .
- Refer to INSTALLING CROSS CONNECTION .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING INTAKE PORT .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .